how to install garden lights with transformer

how to install garden lights with transformer

Best answer

Drive a stake into the ground and attach the transformer to it. Hammer a sturdy wooden stake about 1 foot (0.30 m) into the ground next to the outlet. Then, use the screwdriver to screw the transformer box into the stake to attach it.

People also ask

  • How do you install a transformer for landscape lighting?

  • Transformers are installed simply by plugging them into your outdoor outlet, though some larger ones must be mounted on the wall. Consider what kind of electric cable to use. Cables used in installing landscape lighting is typically buried underground. The cable runs from the transformer to each light fixture to give them power.

  • How do you wire LED lights to a transformer?

  • You can wire the lights in a straight run from the transformer. This means that there is a single length of wire running from the transformer to each of the lights in sequence. Another option is to wire the lights in a loop, with the wire returning to the transformer.

  • How do you install landscape lights?

  • Place lights in desired locations. Run a low voltage cable in the trench but do not bury. A low voltage cable is used as it is only 12v and if it accidentally gets cut, nobody will get hurt. Heath recommends a higher quality brass connector because the plastic ones that come free with the landscape wire are more susceptible to damage and corrosion.

  • How do you set up a lighting system?

  • Lay out your lighting setup outside. Once you have determined a layout, set each light fixture on the ground where it will be installed. Run the cable above ground in the location where it be installed. Wire the lighting system. Attach the wire to each light fixture; many low voltage light fixtures use quick connectors to make this process simple.

    Leave a Reply

    Your email address will not be published. Required fields are marked *